Gehring Honing control (GHC) with Siemens Sinamics
Course No. A100012
USA
- International
- EN
- DE
- USA
- EN
Description
This course provides knowledge of the structure of the Gehring Control Unit (GCU) and Siemens Sinamics S120 as well as the possibilities for diagnostics and troubleshooting.
Course Objectives
- Knowledge of the SPS and the Honing Control Architecture
- Understanding of the Siemens Sinamics S120 control system
- Diagnosis and troubleshooting via various diagnostic systems
Contents
- Structure and functionality of the Siemens SINAMICS S120
- control module
- power components
- motor
- encoder
- DRIVE-CLiQ interface
- Structure and functionality of the Gehring control unit (GCU)
- Data backup and diagnostics
- Determination of the waveform in the setpoint channel
- Internal interconnections to PROFIBUS , PROFINET and CAN-Bus.
- Procedure for troubleshooting and recommissioning
- control of the operating conditions and the release signals
- analysis of warning and error messages Auslesen des Diagnosespeichers- Readings of the diagnostic memory log
- recording of signals via the trace function
- test Operation with operating panel and gauging functions
- Typical errors with power supply, motors, generators and cables
- Procedure in exchanging
- control module
- power supply
- motor
- encoder
- components with safety function
- Hands on training exercises on the training device with SINAMICS S120
- Safety Sign off/Acceptance
- Operation with industrial PC and Gehring user interface as well as manual control unit.
- Parameterization and set up of the Gehring controls
Prerequisites
Qualified electrician, SPS programmer or equivalent with the authority to work on electrical installations, knowledge of safety regulations, knowledge of SPS and NC
Target group
Managers and electronic engineer involved in maintenance, commissioning
Duration
5 days
Number of participants
6 - max. 12
Registration form